Remove all accounts in system “Settings” - “Accounts”.
It’s advised NOT to use god mod on Samsung devices.īackup all data of your non-primary users and all data of your logged-in accounts. WARNING: Some Samsung users encountered boot failure after activating God mode. IMPORTANT: Please read the LIMITATIONS OF GOD / DEMIGOD MODE before proceeding to the following steps.
Manual setup for Island in “God mode” / “Demigod mode” If all goes well, Island will show the app list. If you get error message : Neither user 2000 nor current process has _DEVICE_ADMIN, please review the MIUI-specific steps above in “Preparation”.Īndroid 5.0.x only (not required on Android 5.1+): settings -user 10 put secure install_non_market_apps 1 Copy the full path (after “ package:”), and paste it to replace the potion of the following command:Īfter the installation, proceed to the activation step: (slightly different by Android version)Īndroid 6+: dpm set-profile-owner -user /.IslandDeviceAdminReceiverĪndroid 5.x: dpm set-profile-owner /.IslandDeviceAdminReceiver
It prints the path of the APK file of Island on your device. If you got “Error: couldn’t create User”, execute setprop fw.max_users 10 first, then retry the command above. Remember it and replace the in following commands with this ID. If succeed, you will be prompted with the ID of newly created user (usually 10 or above). Pm create-user -profileOf 0 -managed Island Type adb -d shell to open ADB shell, and execute the following commands one by one in sequence:
If it does not work out, the official Google Android USB driver should work for most Android devices, just manually install it, and select “Android ADB Interface” or “Android Composite ADB Interface”. If no device is listed in the output, your Android device is not correctly recognized by the computer.įor Windows PC, this official guide and driver list for common OEM might be helpful. To check whether the USB-connected Android device is properly recognized by your computer, type the following command in the shell (or Command Prompt on Windows): Preparationįirst of all, you need to connect your Android device to a computer with USB cable, and the official ADB tool provided by Google. If you don’t want device decription (which may significantly degrade overall I/O performance on some low-end devices), it can be avoided with manual setup. If you are prompted to encrypt your device during the setup, it means your device was not pre-encrypted out of box. In these cases, Island could probably still work on your device if setup manually.
But still on some devices, you may got “incompatible with your device” message on Google Play Store, or be notified during the setup with error message “Sorry, your device (or ROM) is incompatible with Island”, or other failures. On most middle to high end Android devices released after 2016, Island can be setup straightforward without hassle. Just running the task to hibernate now, works, so no issues with the task.Setup Guide Island The secret island inside your Android device Setup Guide Screenshot of Notification - (Usually would be 1 app, but since the task did not get run the first time, a second one has been added) I have setup a notify task as well for a counter that updates every time the task runs and it has never increased, which indicates the task has never run. Is there anything further i need to do, cos with this setup AN has never triggered the task to hibernate. In the AN config, I have checked Event behavior, chosen Fill from current & selected the existing notification.Īlso ticked Notification app, and that's it. The idea of the (very simle) profile is to trigger a 'hibernate now' action from greenify, when a notification appears stating that a particular app has hibernation pending or postponed. Long time user of Tasker with AutoLocation, new user for AN & ATools. Looking for some assistance with AutoNotification.